Polyurethane floor varnish gives high protection and a gloss finish to your hardwood floor. Protects bare wood and previously painted, stained and varnished floors. Applied to floor boards and hardwood floors for a natural appearance whilst protecting the surface.
Provides a tough, durable finish, so tough we supply roller rinks with our varnish. Formulated to withstand knocks, scuffs and spills, it is suitable for all interior wood floors. Use to achieve an attractive, high gloss, durable finish.
If you’d like to see some examples of our varnish in use, take a look at our Blog: “Floor Varnish…A Spotlight on Customers’ Projects”. We have featured a couple of examples including a local cocktail bar and Wigan Roller Rink
- Solvent based
- Apply with brush, roller, conventional or airless spray
- Surface dry in 3 hours. Hard dry in 8 hours
- Overcoat after 24 hours
- Keep coated areas dry for a minimum of 24 hours following application.
You might also want to look at our Yacht varnish and our Polyurethane Varnish. Palatine Paints Polyurethane Floor Varnish is available as a high gloss finish. If you’re looking for a more contemporary matt/satin finish to your wood floor, ask about our eggshell version. We also have a coloured gloss floor varnish available.
Preparation:
Proper surface preparation is essential for the success of any protective coating system. Before you begin ensure the area is free from any dust, oil, grease, old coatings and surface contaminants.
All surfaces to be painted should be clean, dry and free from loose and flaking material, dust, grease etc.
Rub down previously gloss painted surfaces with fine waterproof abrasive paper and rinse thoroughly.
Application:
Best results are obtained in warm (minimum 10°C), dry conditions.
Mix thoroughly for approximately 2 minutes using a drill stirrer. A wooden batten at least 25mm wide is also ideal.
Apply an even coat using a brush, short to medium pile roller on smooth surfaces.
For spray application by either airless or conventional spray a dilution ration of no more than 10% is recommended with Palatine White Spirit by volume applying thin coats allowing each one to dry before applying subsequent coats.
Once dried, a second coat can be applied at full strength. This will prolong the life and performance of the coating.
Thinning and Cleaning: Use Palatine White Spirit.
A minimum of two coats is recommended on bare wood to optimize the coatings performance.
Reviews
There are no reviews yet.