Product Description
Thermoguard Safewalls Drywall & Plaster Primer is a water based coating designed for use on bare drywall and plaster before applying Safewalls Insulating Basecoat and Safewalls Anti Viral SFR to a wall or ceiling.
Estimated coverage: 10 to 12.5sqm per litre.
Thermoguard Drywall & Plaster Primer is touch dry in 1 hour and hard dry in 4 hours.
For full details, please see the datasheets.
Application Conditions
Do not apply in temperatures under 8°C or above 30°C.
Maximum relative Humidity below 75%.
Surface should be at least 3°C above the dew point.
Preparation
Surfaces to be clean dry and firmly adhering
Ensure good ventilation
Do not apply while condensation could occur during drying
Application
1 good coat applied at 10-12.5 sqm per litre
Brush or Roller
Apply using a woven short pile roller sleeve or synthetic brush
Spray
Pressure Pot and Gun conventional with hand-portable compressor – thin 5% water
OR Airless Graco 1500, 3500 or equivalent. 3/8” line, 30 mesh filter on machine, no filter in gun. 521, 523, 621 or 623 tip
Ensure coverage is applied as per can i.e., 20 sqm can covers 20 sqm.
Cleaning
Return as much unused material to its original container as possible. Wash brushes, rollers and guns with clean water immediately following use.
Coverage
10-12.5 sqm per litre
Drying Times
In normal conditions product will be touch dry in an hour and fully dry after 4 hours
Reviews
There are no reviews yet.